Table of Contents
Advertisement
MITSUBISHI CNC
4 Edit Screens
4.4.6 Changing a File Name (Rename)
This section explains the method used to change the file name.
Refer to "4.5.2 Selecting a Device, Directory, and File" for details of the device, directory, and file specification method.
(1) Changing a file name
Use the [ ← ] or [ | ← ] key to select file setting
(1)
column A.
Designate the device, directory and file name before
(2)
the change.
Use the [ → ] or [ → | ] key to select file setting
(3)
column B.
Designate the device, directory, and file name after
(4)
the change.
(5)
Press the[Rename A → B] menu.
(6)
Press the [Y] or [INPUT] key.
(Note 1) Make sure the original and new devices are the same.
(Note 2) If the file to be renamed is running or program restarting, an error will occur, and the name will not be changed.
(Note 3) If the file to be renamed is being edited in the custom screen, the operation message "Can't rename
designated file" appears and may not be changed.
(Note 4) If a file that does not exist is designated for the original file, or if an existing file name is designated for the new
file selection, an error occurs, and the name is not changed.
(Note 5) The directory where the file in operation search/check search is stored cannot be renamed. The operation
message "Can't rename designated file" appears.
I - 274
The designated file appears in file setting column A.
The designated file appears in file setting column B.
Renaming of the file starts.A message appears when the
renaming is completed.
Advertisement
Table of Contents
