Appendix 7 Operation Messages; Appendix 7.1 Search-Related Operation Messages - Mitsubishi Electric E70 Series Instruction Manual

MITSUBISHI CNC

Appendix 7 Operation Messages

The following messages display on each screen.

Appendix 7.1 Search-related Operation Messages

Message
Searching
Search completed
Verifying
Verifying stopped
Search error
Setting error
Restart search is completed
Executing restart search
Execute operation search
Can't cancel verify stop
Executing top search
Top search completed
Top search not completed
Can't input data
Input some of ONB
Verifying stop posn already registered
No searched program
Program restarting
Program error
N/B block not found
Restart search interrupted by reset
No. of repetitions exceeded
Program not found
List updating
IV - 146
- The operation search is being executed.
- The operation search was completed correctly.
- The program is being verified.
- The program verification stopped.
- Could not find the designated ONB number.
Review the ONB number or machining program settings.
- The operation search could not be completed correctly.
- When the parameter (#9005) of the tape mode port was set out of the range or
when the port was not connected, an operation search of NC serial was
performed.
- The T code list search failed. Review the program name.
- Could not find the machining program in HD or IC card.
- Check the parameters for HD operation or IC card operation.
- Tape search was executed during the HOST LINK communication.
- The directory name exceeded the display range.
A directory path for which the entire directory cannot be displayed cannot be
designated in the directory name area.
- The search is not possible because ONB number is not designated.
- The restart search was completed.
- The restart search is being executed.
- The program is not searched.
Execute the operation search.
- The compare stop cannot be canceled because the operation is not in a
compare stop.
- The top search is being executed correctly.
- The top search was completed correctly.
- The restart search (type 2) was executed without the top search.
- Data input was attempted during M, S, T, B history display.
- Awaiting ONB number input
- The verify stop position has already been registered.
- The program has not been searched.
- The program is being restarted.
- The restart search was executed in the program with an error.
- The restart search was executed, designating N or B No. not exist.
- Reset was executed during the restart search.
- The restart search was executed, designating the number of repetitions
exceeding the number set in the program.
- The restart search was executed, designating a program No. not exist.
- The file data in the list is being updated. Operation is invalid until the updating
is completed.
Details