Appendix 6.3 Servo/Spindle Alarms (S); Appendix 6.3.1 Servo Errors (S01/S03/S04) - Mitsubishi Electric E70 Series Instruction Manual

MITSUBISHI CNC
Appendix 6 Explanation of Alarms

Appendix 6.3 Servo/Spindle Alarms (S)

Appendix 6.3.1 Servo Errors (S01/S03/S04)

Servo alarm is displayed in the following format.
S S
Alarm class Message
S01 Servo alarm
S03 Servo alarm
S04 Servo alarm
Error No. consists of four digits (0010 to). Servo alarms are explained in ascending order of the error No. The four digits
on the left part of each alarm indicate the error No.
(Note) For the details of servo alarms, refer to your drive unit's instruction manual.
Drive unit alarms
0010 Insufficient voltage
Details
A drop of bus voltage was detected in main circuit.
- Servo stop method: Dynamic stop
- Spindle stop method: Coast to a stop
0011 Axis selection error
Details
The axis selection rotary switch has been incorrectly set.
- Servo stop method: Initial error
- Spindle stop method: Initial error
0012 Memory error 1
Details
A hardware error was detected during the power ON self-check.
- Servo stop method: Initial error
- Spindle stop method: Initial error
0013 Software processing error 1
Details
An error was detected for the software execution state.
- Servo stop method: Dynamic stop
- Spindle stop method: Coast to a stop
0014 Software processing error 2
Details
The current processing processor does not operate correctly.
- Servo stop method: Dynamic stop
- Spindle stop method: Coast to a stop
IV - 60
Axis name
Servo : Axis name
Spindle : "S", "T", "M", "N", "P", "Q", "R"
Error No.
Reset method
Message
Alarm class
Reset method
After removing the cause of the alarm, reset the alarm by turning the
PR
NC power ON again.
After removing the cause of the alarm, reset the alarm by inputting
NR
the NC RESET key.
After removing the cause of the alarm, reset the alarm by turning the
AR
drive unit power ON again.
Resetting methods