Drawing During A Program Check; Changing The Display Range - Mitsubishi Electric E70 Series Instruction Manual

4.3.5 Drawing during a Program Check

During the program check, the tool center path (machine position) is drawn. However, if a radius compensation is applied
on the program being checked, the program path (tool position) and tool center path (machine position) are drawn.
The colors of the lines displayed during the program check are expressed as follows.
Manual feed
Rapid
traverse
Cutting feed

4.3.6 Changing the Display Range

The graphic drawing's scale can be enlarged or reduced, and the position moved or centered.
Operation method (Enlarging the and reducing the drawing)
(1) Press the menu [Display range] .
Zoom Zoom
in out
(2) Press the menu [Zoom In] or [Zoom out].
To enlarge the drawing size:Press the menu [Zoom
In] or [-] key.
To reduce the drawing size:Press the menu [Zoom
out] or [+] key.A solid-line frame appears with
respect to the original scale when enlarging, and a
dotted-line frame appears when reducing.
(3) Press the [INPUT] key.
Programmed path
Tool center move path
Programmed path
Tool center move path
Up Down Left Right
With radius Without radius
compensation compensation
- -
White -
Blue Blue
White -
Green Green
A white frame indicating the display range appears on the
screen.The display range input mode is activated, and the
following menu appears.
Center-
ing
The size of the white frame can be changed by using key
operations.
The display scale changes.
By changing the display scale, the graphic data displayed on
the screen is erased.
When auto graphic is valid, the graphic data is automatically
drawn again on the changed display scale.
E70 Series Instruction Manual
4.3 Program Check (2D)
I - 247