Mode Selection Switch; Jog Feed Mode - Mitsubishi Electric E70 Series Instruction Manual

Hide thumbs Also See for E70 Series:

Table of Contents

MITSUBISHI CNC

4 Operation Mode

4.1 Mode Selection Switch

The MODE SELECT switch is used to determine the controller operation mode.

Rapid traverse feed mode:

Return to reference position

Incremental mode:

Handle feed mode:

Memory Mode:

(Note 1) Refer to the section 1.4 for the running state when a mode is changed to another one during automatic

4.2 Jog Feed Mode

The jog feed mode enables the machine to be moved by hand consecutively at the feedrate set by using the MANUAL

FEED RATE switch. The jog feed mode is started by using the FEED AXIS SELECT switch.

Refer to the section 5 for the MANUAL FEED RATE switch.

Operation procedure

(1) Using the MODE SELECT switch, select the jog mode.

(2) Using the MANUAL FEED RATE switch, set the feedrate.

The feedrate unit is the travel distance (mm) per minute.

(3) To move the controlled axis, turn on the FEED AXIS SELECT switch. The controlled axis is moved while the

switch is turned on.

When the switch is turned off, the controlled axis stops with deceleration.

(Note 1) When the MANUAL OVERRIDE switch on the operation panel is turned ON, the override value set by using

the FEED RATE OVERRIDE switch takes precedence over the feedrate set by using the MANUAL FEED

RATE switch.

Select the mode to move the

controlled axis consecutively at

manual feedrate.

Select the mode to move the

controlled axis consecutively at

rapid traverse feedrate.

Select the mode to position the

controlled axis at the machine

reference position manually.

Select the mode to move the controlled axis for a given distance.

Select the mode to move the controlled axis by using the manual handle.

Select the mode for memory operation.

Select the mode for tape operation.

Select the mode for MDI operation.