Appendix 7.9 Tool (Tool Registration, Tool Life) -Related Operation Messages - Mitsubishi Electric E70 Series Instruction Manual

Appendix 7.9 Tool (Tool registration, tool life) -related Operation Messages

Message
Designated group already exists
Designated group does not exist
Can't register group
Can't delete group
Erase? (Y/N)
Delete all groups? (Y/N)
Can't delete all groups
Pot number not exist
Create new file? (Y/N)
Input the tool number
Clear not possible
Spindle/stndby tool display not possible
Format tool life data? (Y/N)
Tool life format complete
Exists in spindle/standby. Set? (Y/N)
Exists in magazine 1. Set? (Y/N)
Exists in magazine 2. Set? (Y/N)
Exists in magazine 3. Set? (Y/N)
Exists in magazine 4. Set? (Y/N)
Exists in magazine 5. Set? (Y/N)
Appendix 7.9 Tool (Tool registration, tool life) -related Operation Messages
- An already existing group No. was designated when changing the group No.
(Tool life screen (grp))
- An already existing group No. was designated when newly creating the group.
(Tool life screen (grp list))
Designate a group No. that does not already exist.
- Erasing was attempted on the Tool life screen (grp list) of a group that does not
exist.
- The group registration process on the Tool life screen (grp list) failed.
- The group deletion process on the Tool life screen (grp list) failed.
- Message to confirm the erasing.
[Y] or [INPUT]: Erase the data
[N]: Do not erase the data.
- Message to confirm the erasing of all groups.
[Y] or [INPUT]: Erase all groups
[N]: Do not erase all groups.
- All groups' deletion cannot be executed because data protection key (KEY 1)
is validated or automatic operation mode is validated, etc. during all groups'
deletion. All groups' deletion cannot be executed because nothing has been
registered to group, also.
- The set pot number does not exist.
Check the pot number.
- Message to confirm the operation when newly creating data, files, etc.
[Y] or [INPUT]: Newly create.
[N]: Cancel the operation.
- Waiting tool number input.
- The clear range is incorrect.
- The spindle standby cannot be displayed due to the user PLC setting.
Contact the machine tool builder.
- Determines whether to format the tool life management data. When [Y] is input,
the formatting is executed.
- The tool life management data formatting completed.
- An attempt was made to set the same No. as the tool No. for spindle/standby.
- An attempt was made to set the same No. as the tool No. that has been
registered to the valid magazine.
- An attempt was made to set the same No. as the tool No. that has been
registered to the valid magazine.
- An attempt was made to set the same No. as the tool No. that has been
registered to the valid magazine.
- An attempt was made to set the same No. as the tool No. that has been
registered to the valid magazine.
- An attempt was made to set the same No. as the tool No. that has been
registered to the valid magazine.
E70 Series Instruction Manual
Details
IV - 155