Installation; Installation Of Control Unit With Display - Mitsubishi Electric MELDAS 600 Series Connection Manual

3.4 Installation

The control unit with display and each unit are installed in a sealed structure cabinet as a principle.
Observe the following points when installing into the cabinet.

3.4.1 Installation of Control Unit with Display

(1) To stably operate the hard disk drive, install the control unit with display vertically.
(2) Secure the space shown below for ventilation in consideration of the control unit's heat dissipation
and wiring.
(3) When using the PCMCIA option, provide sufficient wiring allowance at the top of the control unit to
wire the Ethernet communication cable and SCSI cable.
Operation pendant
50mm or more
Display un it
Control unit
Display section
150mm or more
(allowance for
heat dissipation
and wirin g)
CHAPTER 3 INSTALLATION
3.4 Installation
(Top)
(Bottom)
Front surface
16
15mm or more
(heat dissipation,
ventilation)
80mm or more
when the expansion
card is mounted
(allowance for wir ing)