Table of Contents
Advertisement
MITSUBISHI CNC
2 Monitor Screens
Operation method(Edit/Search signal search)
It is valid if "2" or "3" is set to parameter "#11031 Cursor pos search".
Carry out the operation search to find the program to
(1)
carry out the cursor position search.
(2)
Turn ON the edit/search signal.
Move the cursor to the block to carry out the cursor
(3)
position search.
(4)
Turn OFF the edit/search signal.
(Note 1) The edit/search window is displayed only on the monitor screens. However, even on the monitor screens, if a
window other than the program edit window (operation search window, menu list, guidance, etc.) is displayed,
the edit/search window will not be displayed.
（Note 2) If the edit/search window is attempted to be closed during editing, a message to confirm whether to save the
data will appear.
When it appears, if save is carried out by pressing the [Y] or [INPUT] key, the operation search will be carried
out starting from the block that has the cursor.
If save is not carried out, the edited data will be aborted, and the operation search will not be carried out.
(Note 3) In the following cases, edit/search is not available with the edit/search window.
- Edit lock B, C is enabled
- Operation search is not carried out
- Edit file size exceeded
- A serial program is being searched
I - 66
The edit/search window is displayed.
The program is displayed starting from the block currently
searched.
(During automatic operation or checking, the program is
displayed from its top.)
The edit/search window is closed, and the operation search is
carried out starting from the block that has the cursor.
When the search is completed, "Search completed" is
displayed.
(Also in the case where the screen is changed with a function
key, etc. and the edit/search window is closed, the operation
search is carried out.)
Advertisement
Table of Contents
