Table of Contents
Advertisement
MITSUBISHI CNC
Appendix 8 User Parameters
【#8113】 Milling Init G16
Set which plane to execute for milling machining after the power is turned ON or reset.
#8113:0, #8114:0 ---> G17 plane
#8113:0, #8114:1 ---> G19 plane
#8113:1, #8114:0 ---> G16 plane
#8113:1, #8114:1 ---> G16 plane
0: Not G16 plane
1: G16 plane
(Note) This parameter is valid for the G code system 2 or 3 ("#1037 cmdtyp"="3" or "4").
【#8114】 Milling Init G19
Set which plane to execute for milling machining after the power is turned ON or reset.
#8113:0, #8114:0 ---> G17 plane
#8113:0, #8114:1 ---> G19 plane
#8113:1, #8114:0 ---> G16 plane
#8113:1, #8114:1 ---> G16 plane
0: Not G19 plane
1: G19 plane
(Note) This parameter is valid for the G code system 2 or 3 ("#1037 cmdtyp"="3" or "4").
【#8116】 Coord rot para invd
Select whether to enable the coordinate rotation by the parameters.
0: Enable
1: Disable
【#8117】 OFS Diam DESIGN
Select tool radius or tool diameter compensation amount to be specified.
0: Tool radius compensation amount
1: Tool diameter compensation amount
【#8119】 Comp. unit switch
Select the setting unit of compensation amount that has no decimal point.
0: 1mm (or 1inch) unit
1: The minimum command unit (follows "#1003 iunit")
【#8120】 FONT SELECTION
Select the font when Simplified Chinese is selected for "#1043 lang".
0: MITSUBISHI CNC GOTHIC font
1: Standard Windows font
(Note) This parameter is available for M700VW only.
【#8121】 Screen Capture
Select whether to enable the screen capture function.
0: Disable
1: Enable
(Note 1) By setting this parameter to "1", and by keeping pushing the [SHIFT] key, screen capture
(Note 2) This parameter is valid with M700VS/M70/M70V/E70 Series.
【#8122】 Keep G43 MDL M-REF
Select whether to keep the tool length offset by high speed manual reference position return during
tool length offset.
0: Will not be kept (Cancel)
1: Kept
IV - 186
will be executed.
Advertisement
Table of Contents
