Table of Contents
Advertisement
MITSUBISHI CNC
2 Monitor Screens
[Tool compensation type III (L system)]
The wear data, tool length data and tool nose data are set separately. These are changed with the sub-menu.
(a) Wear data
Set the tool nose wear amount for each tool used. When the tool offset No. is designated by the tool command
(T command), compensation is carried out matching the tool length data and tool nose data.
(b) Tool length data
Set the tool length in respect to the program basic position of each tool used.
When the tool offset No. is designated by the tool command (T command), compensation is carried out
matching the wear data and the tool nose data.
I - 82
Parameter "#1037 cmdtyp" = 3
Advertisement
Table of Contents
