Mitsubishi Electric E70 Series Instruction Manual page 660

Hide thumbs Also See for E70 Series:

Table of Contents

P242 = not defined at vrble set

The "=" sign has not been commanded when a variable is defined.

- Designate the "=" sign in the variable definition of the program.

P243 Can't use variables

An invalid variable has been specified in the left or right side of an operation expression.

- Correct the program.

P244 Invalid set date or time

Date or time was set earlier than current date or time in the system variables (#3011, #3012) when the

system lock was valid.

- Date or time cannot be changed.

- Correct the program.

P250 No spec: Figure rotation

Figure rotation (M98 I_J_P_H_L_) was commanded though it is out of specifications.

- Check the specifications.

P251 Figure rotation overlapped

Figure rotation command was issued during figure rotation.

- Correct the program.

P252 Coord rotate in fig. rotation

A coordinate rotation related command (G68, G69) was issued during figure rotation.

- Correct the program.

P260 No spec: Coordinates rotation

A coordinate rotation command was issued though it is out of specifications.

- Check the specifications.

P261 G code illegal (Coord rot)

Another G code or a T command has been issued in the block of coordinate rotation command.

- Correct the program.

P262 Illegal modal (Coord rot)

A coordinate rotation command has been issued during modal in which coordinate rotation is not

- Correct the program.

E70 Series Instruction Manual

Appendix 6.12 Program Errors (P)