Mitsubishi Electric E70 Series Instruction Manual page 374

Selecting methods for device, directory, and file name
Device Designation target file
- Machining program
- User macro
- Fixed cycle
NC memory
Other than the machining
program
Other than the NC
All
memory
The device can be selected from the submenu. (The devices that can be used will differ depending on the
specifications.)
One of the following methods can be used to designate the directory (for devices other than the NC memory) and file
name.
- Set the directory path (full path) or file name in the input area, and press the [INPUT] key.
- Press submenu [From list] of the menu [Dir] or [File name]. Move the cursor to the target directory or file name, and
press the [INPUT] key.
A wild card (*) can be used when selecting a file name.
Notes when selecting a file
(1) During directory and file name setting, the designated directory, path or file name will be set, even if it does not
actually exist. This will not cause an error. Note that the previously set directory is overwritten.
(2) When a file in the NC memory other than a machining program is designated, it is not necessary to set the file
name. (The file name is fixed.)
(3) When a file name is selected from the menu, it first is displayed in the input area. However, at this time the file name
has not yet been fixed. Press the [INPUT] key again to fix the file name.
(4) When the key is pressed when setting a file name, the file name in the input area is erased.
(5) When a fixed cycle program is designated, the basic common parameters "#1166 fixpro" must be set. Select
"Memory" for the device, and "Program" for the directory.
Initial directory when the Ethernet is selected
An initial directory is specified at turning the power ON by the following parameter.
- #9706 Host No.
- #9714 Host1 directory
- #9734 Host2 directory
- #9754 Host3 directory
- #9774 Host4 directory
Designation method
Device
Select from the
- (Default)
submenu
Key input in the input
Select from the area, and press [INPUT] -
submenu
Select from the submenu
Key input in the input
Select from the
area, and press [INPUT]
submenu
Select from the list
E70 Series Instruction Manual
6.2 Input/Output Screen
Directory File name
Key input in the input area,
and press [INPUT]
Select from the list
(Fixed)
Key input in the input area,
and press [INPUT]
Select from the list
I - 349