Appendix 7.8 Measurement-Related Operation Messages - Mitsubishi Electric E70 Series Instruction Manual

Appendix 7.8 Measurement-related Operation Messages

Message
TLM switch OFF
Can't take-in skip posn
Can't write coordinates data
Sensor take in not possible
Can't measure
Sensor signal was illegally turned on
Can't write compensation data
Offset No. not found
TLM axis is illegal
TLM axis not returned to ref. position
Can't write rotation parameter
Appendix 7.8 Measurement-related Operation Messages
- Measurement, retrieving of the skip position, writing the coordinates data etc.
was attempted when the TLM switch was OFF.
- Could not retrieve the skip position.
Check the following:
< When measuring the workpiece >
1. Is the name of the axis to be measured designated in the basic axis(I, J, K)?
2. Is the axis that executed the axis movement a measurement axis?
< When measuring the rotation >
1. Is the name of the axis to be measured designated in the coordinate rotation
plane (horizontal axis, vertical axis)?
2. Is the axis that executed the axis movement a measurement axis?
- Could not obtain the measured axis No.
- The measured angle was illegal.
- Could not write into the coordinate system offset.
Measure again.
- The work coordinate offset data was attempted to set when the measurement
counter does not have the necessary values.
- The work coordinate offset date was attempted to set in the slave axis.
- Could not retrieve the position measured with the touch sensor.
Measure again.
- Measurement failed.
- The sensor signal was already ON when the tool measurement mode (TLM)
signal was validated.
- The sensor signal turned ON when there was no axis movement after the tool
measurement mode (TLM) signal was validated.
- The sensor signal turned ON at a position within 100μm from the final entry start
position.
- Move the axis in a safe direction after turning the sensor signal OFF or turning
the tool measurement mode signal OFF.
- The cursor position and the cell for writing the compensation amount (length
dimension, radius dimension) do not match.
Match the cursor position with the cell for writing the compensation amount.
- During manual tool length measurement, the sensor was turned ON designating
tool offset No. not exist.
- During manual tool length measurement, the measurement method was
switched to manual tool length measurement 2 designating tool offset No. not
exist.
- Correctly set the R register of offset No.
- During 2 or more axes movement, the tool length measurement was executed
by turning the sensor ON. Keep the tool away from the sensor and execute the
measurement by one axis.
- The tool length measurement was executed by tuning the sensor ON for the axis
in which dog-type reference point return has not been executed. Carry out
reference point return for the measurement axis.
- The measured result cannot be set in the process parameter.
E70 Series Instruction Manual
Details
IV - 153