Mitsubishi Electric E70 Series Instruction Manual page 145

MITSUBISHI CNC
3 Setup Screens
CAUTION
If the tool compensation amount or workpiece coordinate system offset amount is changed during
automatic operation (including during single block stop), the changes will be valid from the command in the next
block or after several subsequent blocks.
Display items
Display item
(1) Display area
(Note 1) The setting/display ranges are as follows based on the "#1003 iunit(Input unit)", "#1041 I_inch(Initial state
(inch))", and #11050 T-ofs digit type (Tool compensation digit type) setting combination.
#1003
iunit
B
C
When data without the decimal point is input, a set unit can be specified by the parameter "#8119 Comp. unit
switch".
(Note2) The standard settings and display ranges are as follows.
Type Settings
I Compensation data
Length dimension
Length wear
II
Radius dimension
Radius wear
The display range is when the minimum command unit is 1μm ("#1003 iunit"= B, "#1041 I_inch" = 0, "#11050
T-ofs digit type" = 0).
I - 120
Displays the tool compensation data. The displayed cursor can be moved and data set.
Data that cannot be displayed in the display area can be displayed using the keys below.
, : Scroll one line at a time.
, : Change the display contents one page at a time.
Offset No.: This is the compensation data number.
Compensation data: The display items differ depending on the tool compensation type.
[Type I]
Compensation data: Amount in which the shape and wear compensations are combined
[Type II]
Length dimension: Tool length compensation amount.
Length wear: Tool length wear compensation amount.
Radius dimension: Tool radius compensation amount.
Radius wear: Tool radius wear compensation amount.
The setting/display range is different depending on the combination of the settings of "#1003 iunit"
and "#1041 I_inch". (Note 1) (Note2)
#1041 #11050
I_inch T-ofs digit type
0
0
1
0
1
1
0
0
1
0
1
1
Details
This sets the shape and wear combined
compensation amounts.
This sets the tool length compensation amount.
This sets the tool length wear compensation
amount.
This sets the tool radius compensation amount.
This sets the tool radius wear compensation
amount.
Details
Setting/display range
-999.999 to 999.999
-9999.999 to 9999.999
- 99.9999 to 99.9999
- 999.9999 to 999.9999
-999.9999 to 999.9999
-9999.9999 to 9999.9999
- 99.99999 to 99.99999
- 999.99999 to 999.99999
Setting/display range
-999.999 to 999.999
-999.999 to 999.999