Appendix 7.12 Maintenance-Related Operation Messages - Mitsubishi Electric E70 Series Instruction Manual

Appendix 7.12 Maintenance-related Operation Messages

Message
Password is illegal
Input password
Now making back-up
Performing Backup
Backup complete
Backup error
Select directory to backup
Select directory to restore
Executing format
Format complete
Format error
Quit HMI ?(Y/N)
Format NC memory?(Y/N)
Execute SRAM backup ?(Y/N)
PLC running. Does it stop? (Y/N)
Restoring
Restore complete
Auto adjust error
Change Ope. test mode
Test mode sig valid signal is now OFF
Appendix 7.12 Maintenance-related Operation Messages
- The input password is incorrect.
- The [Password] menu key was pressed, and the password input mode was
entered.
Input a password.
- Currently backing up system data and the user PLC program to a specified
device.
- The SRAM data is being backed up on the HD.
- Backup of the SRAM data on the HD has been completed.
- Back up of system data and user PLC program to a specified device has been
completed.
- An error occurred while backing up the SRAM data on the HD.
- Select area by moving cursor, using ↑ and ↓ keys.
Press the "INPUT" key to confirm.
- Select file by moving cursor, using ↑ and ↓ keys.
Press the "INPUT" key to confirm.
- The formatting is being executed correctly.
- The formatting completed correctly.
- The NC memory formatting failed.
Contact the nearest service center.
- Message to confirm the HMI quitting
[Y] or [INPUT]: Quit the HMI.
[N]: Do not quit the HMI.
- Message to confirm the NC memory formatting
[Y] or [INPUT]: Start formatting the NC memory.
[N]: Do not format the NC memory.
- Message to confirm the SRAM back up
[Y] or [INPUT]: The SRAM data is backed up to the HD.
[N]: The SRAM data is not backed up to the HD.
- Message to confirm the PLC STOP
[Y] or [INPUT]: Backup the SRAM data on the HD.
[N]: Do not backup the SRAM data on the HD.
- The system data and user PLC program are now being restored to the NC from
a specified device.
- Restoration of system data and user PLC program to the NC from a specified
device has been completed.
- The H/W status cannot be read properly, and therefore it is not possible to
perform automatic adjustments.
Check the remote I/O unit.
Perform manual adjustments.
- The unit is defective. Replace the unit.
- Operation of the Operation test screen was attempted when the operation
adjustment mode was not selected.
- The operation adjustment mode cannot be selected because the operation
adjustment mode valid signal (R9998/bit0) is 0.
E70 Series Instruction Manual
Details
IV - 159