Table of Contents
Advertisement
(Note 1) The display and setting ranges are as follows based on the "#1003 iunit"and "#1041 I_inch" setting
combination.
When data without the decimal point is input, a set unit can be specified by the parameter "#8119 Comp. unit
switch".
Generally, the center of the tool rest or the tip of the base tool is used as the programmed base position.
(1) The programmed base position is the center of the tool rest:
X-axis tool length
offset amount
Z-axis tool length
offset amount
(2) The programmed base position is the tip of the base tool:
Basic point
X-axis tool length
offset amount
Menus
Same as "3.2.2.1 Wear Data".
#1003 iunit
#1041 I_inch
0
B
1
0
C
1
Basic position
(basic point)
Basic tool
Tool used for
machining
Z-axis tool length offset amount
3.2 Tool Compensation Amount
Setting/display range
-9999.999 to 9999.999
- 999.9999 to 999.9999
-9999.9999 to 9999.9999
- 999.99999 to 999.99999
E70 Series Instruction Manual
I - 131
Advertisement
Table of Contents
