Table of Contents
Advertisement
MITSUBISHI CNC
Appendix 7 Operation Messages
Message
Can't close file for dev A
Can't close file for dev B
Can't write file for dev A
Can't write file for dev B
Can't seek file for dev A
Can't seek file for dev B
File name not designated for dev A
File name not designated for dev B
Can't open directory for dev A
Can't open directory for dev B
Different devices designated in A and B
Timeout error
Checking
Dir create Complete
Can't make directory
Directory pass is illegal
Data protect
Transfer complete
Transferring
Parity H error
Parity V error
File entry over
Program No. not found in the file
Executing format
Format complete
Format error
Framing error
Variable conversion error
IV - 150
- Contact the service center
- Contact the service center.
- Could not write in the file for device B.
Recheck the connection status for device A or the input/output parameter
setting.
- Could not write in the file for device B.
Recheck the connection status for device B or the input/output parameter
setting.
- Contact the service center.
- Contact the service center.
- A file name was not designated for device A.
- A file name was not designated for device B.
- Could not find a directory corresponding to device A.
- Could not find a directory corresponding to device B.
- The same device must be designated for devices A and B, but differing devices
were designated.
- A timeout error occurred when communicating with the external device.
- Cannot be executed during a check
- Creation of the directory has been completed.
- An error occurred while creating the directory.
- The designated directory path name is illegal.
Input a correct directory path name.
- Setting, erasing, parameter setting, etc., of the various data is
prohibited, because the data protect key is validated.
- The data transfer completed correctly.
- The data is being transferred.
- A parity H error was detected.
- A parity V error was detected.
- The No. of registration files designated in the specifications was
exceeded, so the file could not be registered.
- There is no program number in the selected file.
- The formatting is being executed.
- The formatting completed.
- The formatting failed.
- An error occurred between the NC and the external device.
- An error occurred during the M2 macro conversion, and the conversion failed.
Details
Advertisement
Table of Contents
