Table of Contents
Advertisement
(c)
Tool nose data
Set the tool nose radius value (tool nose R), wear radius value (R wear) and tool nose point (tool nose point P)
of the tool nose mounted on the tool for each tool used. When the tool offset No. is designated by the tool
command (T command), offset is carried out matching the tool length data and tool nose data.
CAUTION
If the tool offset amount or workpiece coordinate system offset amount is changed during automatic
operation (including during single block stop), the changes will be valid from the command in the next block or
after several subsequent blocks.
E70 Series Instruction Manual
2.8 Tool Compensation Amount
I - 83
Advertisement
Table of Contents
