Table of Contents
Advertisement
MITSUBISHI CNC
Appendix 8 User Parameters
【#9002】 DATA IN DEV.
Select the device No. for inputting the data. (The device Nos. correspond to the input/output device
parameters.)
---Setting range---
0 to 4
【#9003】 DATA OUT PORT
Select the port for outputting the data such as machine program and parameters.
1: ch1
2: ch2
【#9004】 DATA OUT DEV.
Select the device No. for outputting the data. (The device Nos. correspond to the input/output device
parameters.)
---Setting range---
0 to 4
【#9005】 TAPE MODE PORT
Select the input port for running with the tape mode.
1: ch1
2: ch2
【#9006】 TAPE MODE DEV.
Select the device No. to be run with the tape mode. (The device Nos. correspond to the input/output
device parameters.)
---Setting range---
0 to 4
【#9007】 MACRO PRINT PORT
Select the output port used for the user macro DPRINT command.
1: ch1
2: ch2
9: Memory card
【#9008】 MACRO PRINT DEV.
Select the device No. used for the DPRINT command. (The device Nos. correspond to the input/
output device parameters.)
---Setting range---
0 to 4
【#9009】 PLC IN/OUT PORT
Select the port for inputting/outputting various data with PLC.
1: ch1
2: ch2
【#9010】 PLC IN/OUT DEV.
Select the device No. used for the PLC input/output. (The device Nos. correspond to the input/output
device parameters.)
---Setting range---
0 to 4
【#9011】 REMOTE PRG IN PORT
Select the port for inputting remote programs.
1: ch1
2: ch2
IV - 208
Advertisement
Table of Contents
