Mitsubishi Electric E70 Series Instruction Manual page 193

MITSUBISHI CNC
3 Setup Screens
Menus
Menu
Set the magazine pot number and press the [INPUT] key to position that
Pot
pot number at the top and display the tool number.
No.
The cursor moves to the tool number for that pot number.
This sets or erases the tool No. of spindle and standby tools.
Spindle
The cursor will move to the top tool No. of the spindle and standby tools
standby
and the setting mode will be entered.
This erases all the currently selected magazine tool data (tool number and
D).
Magazn
clear (Note 1) Unselected magazine tool data is not erased.
(Note 2) The spindle and standby data cannot be erased.
Magazn
This designates the magazine No. to be displayed on the screen.
1
The displayed menu differs according to the machine specifications.
:
:
Magazn
5
The cursor moves to the PLC command setting area and the mode
PLC
changes to the setting mode.
command
Tool registration duplication check
When the tool No. is set to the magazine pot and the spindle/standby, tool registration duplication can be checked. Either
of "Executing the duplication check for all valid magazines", "The duplication check invalid" or "Executing the duplication
check only in the selected magazine" can be selected by the parameter "#8922 T-reg-no dup check".
<Priority of duplication check>
Operation
Register tool to magazine pot
(Refer to 3.4.1 Registering a Tool
in the Magazine Pot)
Set tool No. to spindle/standby
(Refer to 3.4.3 Setting/Erasing
the Tool No. of Spindle/Standby
Tools)
I - 168
Details
Setting of the operation parameter "T-reg-no dup check"
0:Executing the duplication
check for all valid magazines
1. Magazine n (n =1,2...)
2. Spindle/standby
1. Spindle/standby
2. Magazine n (n =1,2...)
Type
A
A
A
B
B
2:Executing the duplication
1:The duplication check
invalid
1. Selected magazine
The duplication check is not
executed.
2. Spindle/standby
1. Spindle/standby
The duplication check is not
executed.
2. Selected magazine
Reference
3.4.1 Registering a
Tool in the Magazine
Pot
3.4.3 Setting/Erasing
the Tool No. of
Spindle/Standby
Tools
3.4.3 Setting/Erasing
the Tool No. of
Spindle/Standby
Tools
3.4.5 Switching the
Magazines to be
Displayed
3.4.2 Setting the PLC
Command
check only in the selected
magazine