Table of Contents
Advertisement
MITSUBISHI CNC
Appendix 8 User Parameters
【#8715】 Re-thread SP num
Specify the No. of spindle to use for thread recutting.
If 0 or a non-existent spindle No. is specified, the 1st spindle is used for thread recutting.
---Setting range---
0 to 6
【#8880】 Subpro stor D0: dev
Select the storage destination (device) for the subprogram.
M:Memory, G:HD(Note), F:FD(Note), R:Memory card, D:Data server(Note)
(Note) This is available only with M700/M700VW Series.
When D0 is designated at a subprogram call, the subprogram to be called will be searched from the
device selected with this parameter.
(Example) M98 P (program No.), D0
-> Device: "#8880 Subpro stor D0: dev" device
Directory: "#8881 Subpro stor D0: dir" directory
The device and directory above will be searched.
(Note 1) When the called subprogram is not found in the selected storage destination, a program
(Note 2) When D0 to D4 is not designated at a subprogram call, the subprogram will be searched
【#8881】 Subpro stor D0: dir
Select the storage destination (directory) for the subprogram.
When D0 is designated at a subprogram call, the subprogram to be called will be searched from the
directory selected with this parameter.
Refer to "#8880 Subpro stor D0: dev".
---Setting range---
Directory 48 characters
【#8882】 Subpro stor D1: dev
Select the storage destination (device) for the subprogram.
M:Memory, G:HD(Note), F:FD(Note), R:Memory card, D:Data server(Note)
(Note) This is available only with M700/M700VW Series.
When D1 is designated at a subprogram call, the subprogram to be called will be searched from the
device selected with this parameter.
(Example) M98 P (program No.), D1
-> Device: "#8882 Subpro stor D1: dev" device
Directory: "#8883 Subpro stor D1: dir" directory
The device and directory above will be searched.
(Note 1) When the called subprogram is not found in the selected storage destination, a program
(Note 2) When D0 to D4 is not designated at a subprogram call, the subprogram will be searched
【#8883】 Subpro stor D1: dir
Select the storage destination (directory) for the subprogram.
When D1 is designated at a subprogram call, the subprogram to be called will be searched from the
directory selected with this parameter.
Refer to "#8882 Subpro stor D1: dev".
---Setting range---
Directory 48 characters
IV - 196
error will occur.
from the memory.
error will occur.
from the memory.
Advertisement
Table of Contents
