Table of Contents
Advertisement
MITSUBISHI CNC
6 Operation Panel Switch Functions
(5) Deceleration check in movement including spindle/C-axis
-
The deceleration check for spindle/C-axis movement command is as described in the table below.That is
because a vibration and so on occurs in the machine when the position loop gain (#13002 PGN) is changed
during the axis movement.
Parameter
Rapid traverse command
Inpos
G0 → XX
(#1193)
(G0+G9 → XX)
0
Command deceleration check
1
In-position check
(Note 1) When G1 command is issued, the in-position check is performed regardless of the deceleration check
parameter.
(Note 2) XX expresses all commands.
II - 50
Other than rapid traverse command
Parameter
AUX07/BIT-1
G1 → G0
(#1223/BIT-1)
(G1+G9 → XX)
0
In-position check
(Applicable only to SV024)
1
(G1 : other than G0 command)
G1 → G1
No deceleration check
Advertisement
Table of Contents
