Table of Contents
Advertisement
MITSUBISHI CNC
Appendix 8 User Parameters
【#9606】 HAND SHAKE
Select the transmission control method.
"3" (DC code method) should be set for computer link B.
0: No control
1: RTS/CTS method
2: No handshaking
3: DC code method
【#9607】 TIME-OUT SET
Set the time-out time at which an interruption of data transfer during data input/output should be
detected.
"0" means infinite time-out.
---Setting range---
0 to 999 (1/10s)
【#9608】 DATA CODE
Set the code to be used for the data description.
Refer to "#9603 PARITY EFFECTIVE".
0: ASCII code
1: ISO code
【#9609】 LINK PARAM. 1
bit1: DC1 output after NAK or SYN
Select whether to output the DC1 code after the NAK or SYN code is output.
0: Not output the DC1 code.
1: Output the DC1 code.
bit7: Enable/disable resetting
Select whether to enable the resetting in the computer link.
0: Enable
1: Disable
【#9610】 LINK PARAM. 2
Bit 2: Specify the control code parity (even parity for the control code).
Select whether to add an even parity to the control code, in accordance with the I/O device
specifications.
0: Not add a parity bit to the control code
1: Add a parity bit to the control code
Bit 3: Parity V
Select whether to enable checking of parity V in one block at the input of the data.
0: Disable
1: Enable
【#9611】 Link PARAM. 3
Not used. Set to "0".
【#9612】 Link PARAM. 4
Not used. Set to "0".
【#9613】 Link PARAM. 5
Not used. Set to "0".
【#9614】 START CODE
Select the code used to command the first transfer of file data.
This parameter is used for a specific user. Normally set "0".
0: DC1 (11H)
1: BEL (07H)
IV - 228
Advertisement
Table of Contents
