Table of Contents
Advertisement
【#8218】 Dir cmd retrct amt
Set in which direction and how much the tool escapes when the operation is halted during direct
command mode. (Radius value)
The tool does not escape when "0" is set.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8219】 Hob retract amount 1
Set the retract amount using the radius value when the Hob retract amount selection signal is OFF.
Retract is carried out in the negative direction if a negative value is set.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8220】 Hob retract amount 2
Set the retract amount using the radius value when the Hob retract amount selection signal is ON.
Retract is carried out in the negative direction if a negative value is set.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8221】 Hob retract speed
Set the retract speed during hobbing.
---Setting range---
1 to 1000000 (mm/min)
【#8300】 P0 (for L system only)
Set the reference X-coordinates of the chuck and the tail stock barrier.
Set the center coordinate (radius value) of workpiece by the basic machine coordinate system.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8301】 P1 (for L system only)
Set the area of the chuck and tail stock barrier.
Set the coordinate from the center of workpiece (P0) for X-axis. (radius value)
Set the coordinate value by basic machine coordinate system for Z-axis.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8302】 P2 (for L system only)
Set the area of the chuck and tail stock barrier.
Set the coordinate from the center of workpiece (P0) for X-axis. (radius value)
Set the coordinate value by basic machine coordinate system for Z-axis.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8303】 P3 (for L system only)
Set the area of the chuck and tail stock barrier.
Set the coordinate from the center of workpiece (P0) for X-axis. (radius value)
Set the coordinate value by basic machine coordinate system for Z-axis.
---Setting range---
-99999.999 to 99999.999 (mm)
E70 Series Instruction Manual
IV - 191
Advertisement
Table of Contents
