Mitsubishi Electric E70 Series Instruction Manual page 188

To set the measurement results of the other axes,
(7) repeat (6).
Example) 5 [INPUT]
(8) Press the [Offset write] menu.
Input an offset No.
(9)
(Example) 3 [INPUT]
(Note 1) Compensation amount is written in diameter value for diameter command, or in radius value for radius
command.
(Note 2) When offset write is executed for an axis that has not completed zero point return, the operation message
"TLM axis not returned to ref. position" will appear.
(Note 3) When the parameter "#1124 ofsfix" is "0", the cursor moves to the next offset No. However, when "#1124
ofsfix" is "1", the cursor does not move to the next offset No.
(Note 4) When the parameter "#11017 T-ofs set at run" is "1", the tool compensation amount data can be set even
during automatic operation or operation pause.
(Note 5) If the measurement result exceeds the setting range of the tool compensation amount, the operation message
"Setting error" will appear and the offset write cannot be executed.
E70 Series Instruction Manual
The value "5" is set to the 2nd line of "Work meas".
(Note 1) Compensation amount is written in diameter value for
diameter command, or in radius value for radius command.
The operation message "Input offset No." displays.
The result of "Measure value - Work meas" will be set in the
specified offset No. (X and Z axes). Specified offset No will
display at the top and the cursor will move to the same line.
(Note) The measurement value is cleared and the highlight of
the menus ([Measure X] to [Measure C]) is canceled.
3.3 Tool Measurement
I - 163