Mitsubishi Electric E70 Series Instruction Manual page 166

Hide thumbs Also See for E70 Series:

Table of Contents

This writes the value displayed in "Mea value" as the tool compensation amount.

The wear amount is cleared to "0" for the tool compensation type II.

The tool compensation amount cannot be written in when the menu [Offset No.]

or [Surface hight] is highlighted.

(Note) When the parameter "#8924 MEAS. CONFIRM MSG" is "1", this menu is

highlighted and the operation message "OK? (Y/N)" appears. The measurement

result is written as tool compensation amount by pressing [Y] or [INPUT] key.

Even if other key is pressed, the result is not written.

When this menu is pressed again while displaying the message, the highlight is

released and the operation message is erased.

When the offset No. is set and the [INPUT] key is pressed, the tool compensation

data with that number at its head appears.

The cursor moves to the length dimension data of the top line of that data.

This sets the reference surface height data. (The cursor moves to the reference

surface height.)

When the data is set in the input area and the [INPUT] key is pressed, the

reference surface height is set.

This changes the mode to the tool length measurement mode.

This mode is enabled when turning ON the power.

(The cursor moves to the length dimension position for tool compensation type

II. Only the length dimensions and length wear are displayed when "#11050 T-

ofs digit type" is set to "1".)

This changes the mode to the tool radius measurement mode.

(The tool measurement type is valid only for tool length measurement II.)

(The cursor moves to the radius dimension position for tool compensation type

II. Only the radius dimension and radius wear are displayed when "#11050 T-ofs

digit type" is set to "1".)

E70 Series Instruction Manual

3.3 Tool Measurement

3.2.1 Setting the Tool

Compensation Data

Carrying Out Tool

Length Measurement

Carrying Out Tool

Radius Measurement