Table of Contents
Advertisement
(2) L type
(a) Tool life management I
Tool life management I format is as follows.
Address
Definition
N
Tool No.
P
Time-used
E
Time-max
Q
Count-used
F
Count-max
S
Status
B
AUX.
[Output example]
%
LIFEL1( TOOL LIFE DATA)
$1
N1 P12.34.56 E45.56 Q6 F7 S1 B0
N2 P2.3.4 E5.6 Q7 F8 S1 B1
N3 P99.59.59 E99.59 Q9999 F9999 S2 B99
N4 P0.0.0 E0.0 Q0 F0 S0 B0
:
N80 P0.0.0 E0.0 Q0 F0 S0 B0
%
(b) Tool life management II
Tool life management II format is as follows.
Address
Definition
G
Group No.
M
Method
E/F
Service life
The tool No. is shown with the value following N.
The time-used is shown with the value following P.
The time-max is shown with the value following E.
The count-used is shown with the value following Q.
The count-max is shown with the value following F.
The status of tool life management is shown with the value following S.
The auxiliary data is shown with the value following B.
The group No. for tool life management is shown with the value following G.
The tool life management method is shown with the value following M.
0: Life management is carried out using the time of cutting feed execution.
1: Life management is carried out using the number of usages.Counting the number of
usages is executed when changing from rapid traverse command (G00, etc.) to cutting
feed command (G01,G02,G03, etc.). Note that if rapid traverse command or cutting feed
command that does not involve any movement is executed, usage will not be counted.
The life data (service lifetime) is shown with the value following E.The life data (service
life count) is shown with the value following F.
(Note 1) When the combination of the setting of tool life management method and
address is illegal, error occurs at data input.
(Note 2) The USED data will be incremented when the LIFE data is "0", but no judgment
if the service life is reached will be made.
E70 Series Instruction Manual
6.2 Input/Output Screen
Details
Details
I - 369
Advertisement
Table of Contents
