Mitsubishi Electric E70 Series Instruction Manual page 738

【#8934】 Disable wear comp
Select whether to disable the setting of tool wear compensation amount.
0: Not disable
1: Disable
The wear compensation amount covers the following data according to the tool compensation type.
- Compensation type I ("1" in "#1037 cmdtyp(command type 1)")
... This parameter is disabled.
- Compensation type II ("2" in "#1037 cmdtyp(command type)")
... Length wear and radius wear
- Compensation type III ("3" in "#1037 cmdtyp(command type)")
... Tool wear and tool nose wear
【#8935】 W COORD CONFIRM
Select whether to display confirmation message when setting workpiece coordinate system offset in
[Simple setting] menu.
0: Not display
1: Display
【#8936】 Delete leading 0
In creating a file, or in transferring a file, if the file name of the new file, or the file name of the transfer
destination consists only of numerical figures, 0 of the file name head will be deleted from the name.
0: Designated file name (0 remains in the file name)
1: 0 will be deleted from the file name
【#8937】 File sort volume
Set the maximum number of files to sort in the memory card and DS lists.
If the setting is large, update of the list may take longer.
With M70V/M70/E70 Series, the maximum number will be 64 regardless of the setting of this
parameter.
---Setting range---
64 to 1000(M700/M700VW Series)
64 to 250(M700VS Series)
Standard: 64
【#8938】 Edit-Not show Prg
Select whether to enable the automatic display on the Edit screen, when selected, of the programs
searched by operation/check search or the MDI programs in MDI mode.
0: Enable the automatic display
1: Disable the automatic display
【#8939】 Undo confirm msg
Display a confirming message when operating the [Undo] menu.
0: Not display a confirming message
1: Display a confirming message
【#8940】 Set select display
Select what to display in the selectable display area.
0: Common variable
1: Local variable
2: Workpiece coordinate system offset
3: All spindles' rotation speed
4: Expanded counters
5: Tool center coordinate display
6: Custom release window
(Note 1)This parameter is available for 15-type display unit only.
(Note 2)Tool center coordinate display is available only when any of the 5-axis related options is
enabled.
E70 Series Instruction Manual
IV - 205