Table of Contents
Advertisement
MITSUBISHI CNC
Appendix 8 User Parameters
【#8019】 R COMP
Set a compensation coefficient for reducing a control error in the reduction of a corner roundness
and arc radius.
The larger the set value is, the smaller the theoretical error will be. However, since the speed at the
corner goes down, the cycle time will be extended.
Coefficient = 100 - set value
(Note) This function will be enabled when "#8021 COMP_CHANGE" is set to "0".
---Setting range---
0 to 99 (%)
Theoretical radius decrease error amount
Displays the theoretical radius decrease error amount, ΔR(mm), from the automatic calculation by
NC.
Path after
servo control
Theoretical radius decrease amount in arc
R5mm arc deceleration speed
Displays a deceleration speed(mm/min) along an arc of 5(mm) radius.
R1mm arc deceleration speed
Displays a deceleration speed(mm/min) along an arc of 1(mm) radius.
IV - 178
Command path
R
F
+
Advertisement
Table of Contents
