Table of Contents
Advertisement
3.4.1 Registering a Tool in the Magazine Pot
Operation method (Selecting a magazine No.)
(1)
Press the menu [Magazn 2].
(Note)
The No. of magazines differs according to the machine specification.
Operation method (Registering the tool in the magazine pot)
(1)
Designate the pot No.
[Pot No.] 21 [INPUT]
(2)
Input the tool number.
50 [INPUT]
When the [INPUT] key is pressed without setting a
value, the tool number does not change and the
cursor moves to the "tool number" for the next pot
number.
(Note 1) To set "D", use the
Refer to the manual issued by the machine tool builder for details on the "D" functions and purposes.
(Note 2) The duplication check is executed for only the tool No. The check does not depend on the setting of "D".
(Note 3) If parameter "#8922 T-reg-no dup check" is set to "1", the operation message will not appear even when the tool No.
duplicates.
key to move the cursor.
E70 Series Instruction Manual
The tool data of the set magazine No. appears.
The tool data appears with the designated pot No. at the head.
The cursor moves to the tool No. setting column.
The input tool number displays and the cursor moves to the
next tool number.
When the duplication check is valid, the operation message
"Exists in magazine 1. Set? (Y/N)" or "Exists in spindle/
standby. Set? (Y/N)", etc. appears if the input tool No. already
exists in valid magazine, spindle/standby.
3.4 Tool Registration
I - 169
Advertisement
Table of Contents
