Table of Contents
Advertisement
Operation method (Changing a group No.) (M system)
(1)
Press the [Grp No. change] menu.
(2)
Designate the group No. after changing.
112 [INPUT]
(Note)
An error occurs if the group No. duplicates a pre-existing group No.
Operation method (Setting the tool life data) (M system)
Move the cursor to the data to be set using the
(1)
, [ ↑ ], [ ↓ ], [ | ← ] and [ → | ] keys.
It is possible to move to the line after the registered
line.
Set a tool No. for this line to newly register tool life
management data.
(2)
Set a value.
20 [INPUT]
(Note 1) The other settings will be invalid when the tool ST (status) setting data are not set.
(Note 2) The same tool cannot be registered in more than one group.
(Note 3) If the tool No. is not set, the other data cannot be set.
(Note 4) Change the "Method" to initialize the related items.
Change the tool life management method (the 1st digit) to clear the "Life" and "Usage", and also change the
units.
Change the tool radius compensation data (the 2nd digit) to clear the "Radius Compensation".
Change the tool length compensation data (the 3rd digit) to clear the "Length Compensation".
Figures after the decimal point are also changed in line with the specifications.
Operation method (Copying/pasting the tool life data) (M system)
(1)
Move the cursor to the line to be copied.
(2)
Press the menu [Line copy].
Move the cursor to the line where the data is to be
(3)
pasted.
(4)
Press the [Line paste] menu.
(Note 1) Once copied, the data is held until a new data item is copied.
(Note 2) It is not possible to paste into a line for which a tool No. has not been set.
The menu is highlighted.
The group No. changes to "112".
,
The menu is highlighted.
The set value displays.
The cursor moves one position to the right.
The menu is highlighted.
The background color of the copied data changes to light blue.
(The color changes even when scrolling horizontally.)
The copied tool life management data is written to the data
(excluding the tool No.) in the line where the cursor is located.
The background color returns to normal.
The cursor moves to "ST".
E70 Series Instruction Manual
3.5 Tool Life Management
I - 183
Advertisement
Table of Contents
