Table of Contents
Advertisement
MITSUBISHI CNC
3 Setup Screens
(c) Simple operation mode 2
When the parameter "#8957 T meas (L)-Simple mode" is "2", the compensation amount is written to the offset No.
of the cursor position at the time of the [Offset write] menu pressed.
(Example) Carrying out tool measurement for offset No.3, X axis and Z axis.
Select the tool to be measured with manual numerical
(1)
value command. (Refer to "3.10 Manual Numerical
Value Command" for details.)
Point the cursor to the position (offset No. 3) where
the measurement result are to be set with [ ↑ ], [ ↓ ],
(2)
PAGE
, or
key.
PAGE
Cutting is executed in the longitudinal direction.
(3)
(Forthe Z axis, end face cutting is executed.)
Press the address key of the axis to measure or the
(4)
[Measure X] menu, without retracting the tool from the
cutting end point.
(5)
Retract the tool and measure the workpiece.
Set the workpiece measurement result in "Work
(6)
meas".
Example) 10 [INPUT]
I - 164
The tool to be measured is selected.
The cursor is displayed at the offset No.3
The workpiece is cut.
The measure value is memorized. The memorized value
is displayed in "Measure value", and the cursor moves
to the selected axis (X axis) of the "Work meas".
The operation message "Input workpiece measurement
value" is displayed.
The value 10 is set in the top line of "Work meas".
The cursor moves to the offset amount
(Note 1) Set a diameter value for diameter command
and a radius value for radius command.
(Note 2) When re-entering the workpiece measurement
value, press the [Measure X] menu and do (3) to (6)
again.
Advertisement
Table of Contents
