Table of Contents
Advertisement
MITSUBISHI CNC
6 Operation Panel Switch Functions
6.10 Manual Absolute
When the MANUAL ABSOLUTE switch is turned ON, while the program coordinate system is not updated, the
coordinate position is updated by the distance in which the tool has been moved manually. If the switch is OFF, the
program coordinate system is updated when the tool is manually moved.
M 0
W
-Y
(a) Feed hold stop
(b) Programmed path (absolute command)
(c) Manual interrupt (The coordinate system W is not shifted)
(d) Path after manual interrupt
(e) Tool passes along same path as that programmed
(f) With manual absolute signal ON
M 0
W
-Y
(a) Manual interrupt (The coordinate system W is shifted)
(b) Manual interrupt amount
(c) Feed hold stop
(d) Programmed path (absolute command)
(e) Manual interrupt (The coordinate system W is shifted)
(f) Path after manual interrupt
(g) Path is shifted by an amount equivalent to manual interrupt value (Zero point of the coordinate system W
moves)
(h) With manual absolute signal OFF
II - 26
(a)
(b)
(d)
(e)
(f)
(a)
(b)
(c)
W
(f)
(g)
(h)
X
(c)
X
(d)
(e)
Advertisement
Table of Contents
