Table of Contents
Advertisement
MITSUBISHI CNC
3 Setup Screens
Display items
Display item
Manual measurement
(1)
status display
Counter display
(2)
L meas : Z (Axis name) The axis selected in the parameters "#8711 TLM L meas axis" and "#8712 TLM D meas axis"
R meas : X (Axis name)
Reference surface
(3)
height
(4)
Guide drawing
(5)
Tool compensation data
I - 140
This displays the manual measurement status.
Refer to the "Manual measurement status display" section for further details.
TLM value : This displays the value during measurement.
This will be the same as the machine position until the sensor is contacted.
This will be the skip coordinate position after the sensor is contacted.
Measurement value :
For tool length measurement type I: TLM value - Reference surface height
For tool length measurement type II: TLM value - Reference surface height + TLM reference
length
For tool radius measurement, measurement result is displayed in absolute value.
(Note) The TLM value counter differs according to the parameter "#1328 TLM type" value.
0 : The position when the measurement switch was turned ON is displayed as 0.
1 : The display is based on the machine zero point.
is the target axis for the measurement.
This displays a value for the reference surface height.
The setting range is from -99999.999 to 99999.999(mm)
This displays the measurement image. The contents of the guide drawing will differ
depending on the tool measurement type.
Tool length measurement I guide drawing
Tool length measurement II guide drawing
This displays the tool compensation data. Depending on the tool compensation type (I/II), the
display details of the displayed tool compensation data will differ.
Cursor movement and data input operations are same as tool compensation types I and II.
Details
Advertisement
Table of Contents
