Mitsubishi Electric E70 Series Instruction Manual page 673

Hide thumbs Also See for E70 Series:

Table of Contents

MITSUBISHI CNC

Appendix 6 Explanation of Alarms

P610 Illegal parameter

- The parameter setting is not correct.

- G114.1 was commanded while the spindle synchronization was selected with the PLC interface

- G110 was commanded while the mixed control (cross axis control) was selected with the PLC

interface signal.

- G125 was commanded while the control axis synchronization across part systems was selected

with the PLC interface signal.

- G126 was commanded while the control axis superimposition was selected with the PLC interface

- Correct the settings of "#1514 expLinax (Exponential function interpolation linear axis)" and "#1515

expRotax (Exponential function interpolation rotary axis)".

- Correct the program.

- Correct the parameter settings.

P611 No spec: Exponential function

There is no specification for the exponential interpolation.

- Check the specifications.

P612 Exponential function error

A travel command for exponential interpolation was issued during mirror image for facing tool posts.

- Correct the program.

P700 Illegal command value

Spindle synchronization was commanded to a spindle that is not connected serially.

- Correct the program.

- Correct the parameter settings.

P900 No spec: Normal line control

A normal line control command (G40.1, G41.1, or G42.1) was issued though it is out of specifications.

- Check the specifications.

P901 Normal line control axis G92

A coordinate system preset command (G92) was issued to a normal line control axis during normal line

- Correct the program.

P902 Normal line control axis error

- The normal line control axis was set to a linear axis.

- The normal line control axis was set to the linear type rotary axis II axis.

- The normal line control axis has not been set.

- The normal line control axis is the same as the plane selection axis.

- Correct the normal line control axis setting.