Mitsubishi Electric E70 Series Instruction Manual page 676

Hide thumbs Also See for E70 Series:

Table of Contents

P954 Inclined face command error

The address to issue the inclined surface machining command is incorrect.

- Check the program.

P955 Inclined face coord illegal

Impossible to define an inclined surface with the values you specified.

- Check the program.

P956 G68.2P10 surface not defined

The coordinate system for the machining surface selected with G68.2P10 has not been defined.

- Set the machining surface so that the coordinate system can be defined.

P957 Tool axis dir ctrl cmp amt 0

When the tool axis direction control type 2 (G53.6) was commanded, a tool length offset No. whose

compensation amount is 0 was commanded.

- Correct the program. Set the tool length compensation amount, or command a tool length offset No.

whose compensation amount is not 0.

P960 No spec: Direct command mode

G05 P4 was commanded while direct command mode option is OFF.

- Check the specifications.

P961 Invalid during dir cmnd mode

- A G code other than G05 P0 was commanded in direct command mode.

- A sequence No. command, F code command, MSTB command or variable command was issued.

- A corner chamfering command or corner R command was issued.

- A travel command was issued to an axis that had not been command in the G05 P4 block.

- Check the program.

P962 Dir cmnd mode cmnd invalid

G05 P4 was commanded in a modal where direct command mode is not available.

- Check the program.

P963 Illegal direct cmnd mode cmnd

The commanded coordinate value was beyond the maximum travel distance in direct command mode.

- Correct the coordinate value in direct command mode.

E70 Series Instruction Manual

Appendix 6.12 Program Errors (P)