Mitsubishi Electric E70 Series Instruction Manual page 684

Message
Merge complete
Merge execution
Memory alloc error
Rename complete
OK? (Y/N)
I/O not ready
I/O parameter error
I/O port busy
FD write protect
PLC running
FD not ready
MemoryCard not ready
DS not ready
USB memory not ready
Can't write in READ-ONLY file
Condense complete
A directory does not exist
Setting complete normally
Guidance data loading
No guidance data in MemoryCard
Appendix 7.6 Data Input/Output-related Operation Messages
- The data merge completed.
- The data merge is being executed.
- Securing of the communication data range failed.
- The rename has been completed.
- Message to confirm the operation.
[Y] or [INPUT]: Execute the operation
[N]: Cancel the operation.
- An error occurred between the NC and the external device.
- The external device settings and input/output parameters do notmatch.
- Input/output was not possible as the I/O port is busy.
- The FD is write-protected.
Release the write protection.
- An attempt was made to input a user PLC during PLC RUN.
- Stop the PLC on the maintenance screen.
- An attempt was made to perform an FD operation search with no FD.
- An attempt was made to display the FD list with no FD.
- An attempt was made to perform operations with no memory card.
- An attempt was made to perform operations with no data server.
- Operation was attempted when an USB memory is not inserted.
- Contact the service center.
- Condensing has been completed.
- The specified directory does not exist.
- Decryption code setting file of the system lock was set normally.
This will display only when the guidance data is loading from a memory card.
It will display when a memory card for guidance is inserted after the NC has
started and reading will take a few seconds to complete. (E70 only)
Guidance data from memory card could not be read. Insert memory card with
guidance data before displaying guidance. (E70 only)
E70 Series Instruction Manual
Details
IV - 151