Mitsubishi Electric E70 Series Instruction Manual page 291

MITSUBISHI CNC
4 Edit Screens
Initial directory when the Ethernet is selected
An initial directory is specified at turning the power ON by the following parameter.
- #9706 Host No.
- #9714 Host1 directory
- #9734 Host2 directory
- #9754 Host3 directory
- #9774 Host4 directory
Operation method (Selecting an NC memory program)
(1) Press the [M] short cut key.
(2) Press the menu [File set] .
<First page>
Memory Serial
<Second page>
Comment
Program
nondisp
By pressing the operation menu at this point, it is possible to change the device.
When the menu [Program] or [Program all] is selected, the setting of "File name" column is cleared.
When the device is only the memory, the menu [Program] or [Program all] is valid.
When selecting the file name from the list
Move the cursor to the file name to be selected, and
fix.
(3)
[ ↑ ],[ ↓ ] [INPUT]
When inputting the file name from the input area:
Input the file name.
(3)
10013 [INPUT]
I - 266
Memory
USB
Ethernet
Memory
card
Program
all
The device name changes to "Memory".
"Program" appears in the directory.
The NC memory program list and input area appear.
The menu appears as follows.
Top Bottom
Retn
jump jump
List Sort
Retn
update change
The selected file name appears.
The list and input area are cleared, and the screen returns to
the original display.
The menu returns to its original display.
The input file name appears.The list and input area are
cleared, and the screen returns to the original display.The
menu returns to its original display.