Mitsubishi Electric E70 Series Instruction Manual page 184

Hide thumbs Also See for E70 Series:

Table of Contents

When the parameter "#8957 T meas (L)-Simple mode" is "2", the compensation amount is written to the offset No.

of the cursor position at the time of the [Offset write] menu pressed.

(Example) Carrying out tool measurement for offset No.4, X axis and Z axis.

Select the tool to be measured with manual numerical

value command. (Refer to "3.10 Manual Numerical

Value Command" for details.)

Point the cursor to the position (offset No. 4) where

the measurement result are to be set with [ ↑ ], [ ↓ ],

Manually align the tool nose with the measurement

Press the axis address key (X axis) to be measured or

the [Measure X] menu.

To measure the other axes at the same time, press

the axes address key to be measured (Z axis) or the

[measure Z] menu.

Press the [Offset write] menu.

(Note 1) An offset is written in diameter value for diameter command or in radius value for radius command.

(Note 2) If writing the offset data is performed for an axis in which reference position return has not been executed, the

operation message "TLM axis not returned to ref. position" will appear.

E70 Series Instruction Manual

The tool to be measured is selected.

The cursor is displayed at offset No.4

The calculation result of X axis is displayed in "Measure

The [ measure X] menu is highlighted.

Keeping the result of "Measure value" of X axis, the

calculation result of the Z axis is displayed in "Measure

The [Measure Z] menu is highlighted.

The measurement values will be set in the

compensation amount (X and Z axes) of the offset No.4

(the cursor position).

(Note) The measurement value is cleared and the

highlight of the menus ([Measure X] to [Measure C]) is

3.3 Tool Measurement