Table of Contents
Advertisement
MITSUBISHI CNC
3 Setup Screens
Menus (M system)
Menu
This displays the data of a group when that group No. of tool life management
Group
data is set and the [INPUT] key is pressed. The group No. can be referred to in
No.
the group list. (Note 1)
Line
Copies one line of tool life management data where the cursor is located.
copy
The copied tool life management data is written to the data in the line where the
cursor is located.
If the copied data is changed after the menu [Line copy] is pressed, the data
Line
paste
before changing is written when pasted.
The data in the copied line can be pasted as many times as is required until new
data is copied.
This erases a designated line (multiple lines possible) of tool life management
data.
The first and the last line No. of the data to be erased is specified with a "/"
Line
clear
separating the Nos.
If the [INPUT] key is pressed without specifying a line, the data in the line where
the cursor is located is erased.
This changes a group No.
Grp No.
If a new group No. is set and the [INPUT] key pressed, the group No. changes.
change
An error occurs if a pre-existing group No. is set. (Note 1)
This scrolls the display of the tool life management data to the left and right.
The items below display alternately each time the menu is pressed.
Horiz
scroll
1. Tool No., ST, Mthd, L compen, R compen
2. Tool No., Auxil, Life, Used
Prev
Displays the previous group No. data. (Note 1)
group
Next
Displays the next group No. data. (Note 1)
group
Group
This displays the list of tool life data groups. (Note 1)
list
Group
This creates a new group. (Note 2)
regist
Group
This erases all tool life management data contained in the currently displayed
delete
group No. (Note 2)
(Note 1)This menu is not valid for the tool life management III.
(Note 2)This menu will not be displayed for the tool life management III.
Operation method (Designating a group No.) (M system)
(1)
Press the [Group No] menu.
(2)
Designate the group No. to be displayed.
12 [INPUT]
(Note)
If a group No. that does not exist is designated, a message appears to confirm the creation of a new No. A
new group is created if [Y] or [INPUT] is pressed.
I - 182
Details
The menu is highlighted.
The tool life data of the designated group No. appears, and the
cursor moves to the head of the data.
Type
Reference
"Designating a group
A
No."
C
"Copying/pasting the
tool life data"
C
"Erasing one line of tool
life management data"
A
"Designating and
erasing a line"
A
"Changing a group No."
C
C
C
C
A
"Registering a group"
A
"Erasing a group"
Advertisement
Table of Contents
