Table of Contents
Advertisement
MITSUBISHI CNC
4 Edit Screens
Notes for playback editing
(1) Playback editing of a program in automatic operation or program restart is not possible.
(2) Up to 95 characters can be edited in the playback editing area.
(3) If the screen system is changed or the program file is opened when the input program is in the playback edit area,
the program being edited will be aborted.
(4) Other files can be opened during playback editing. Playback editing can be continued even when other file is
opened. However, if an incremental value is designated, the playback movement amount will be cleared to 0 for all
axes. A new file can be created and edited, and MDI editing carried out in the same manner.
(5) If the program being playback edited automatically starts, playback editing cannot be continued.
(6) The playback movement amount after playback editing will differ according to the parameter "#1126 PB_G90" state
and the commanded G code. The playback movement amount after [INPUT] is pressed is calculated for each block
that has been playback edited.
X axis playback
movement amount
before editing
X 100.000
(7) The playback editing is disabled during mass-editing.
(8) If the file to be played back edit is being edited in the custom screen, the operation message "Can't write into being
edited file" appears and may not be able to edit.
(9) Do not set the same address to the parameter "#1013 axname" and "#1014 incax". If the same address is set, the
absolute counter has priority.
(10) The playback editing cannot be enabled for an axis of auxiliary axis state. When an axis address of auxiliary axis
state is input, a setting error will occur.
I - 236
Details to be
playback edited
For an absolute value
X 100.000
The program position + manual
G01 X10.;
interrupt amount is inserted as the
playback movement amount.
X 10.000
The command value (X10.)
G92 X10.;
following G92 is inserted as the
playback movement amount.
X axis playback movement amount after [INPUT]
For an incremental value
X 90.000
The difference of the axis command value
(X10.) and playback movement amount
before [INPUT] (X100.) is inserted as the
playback movement amount.
X 0.000
Regardless of the command value
following G92, 0 is inserted as the
playback movement amount.
Advertisement
Table of Contents
