Figure 1.1 Setup Workflow - Fujitsu PRIMEQUEST 500A Series Installation Manual

CHAPTER 1 PRIMEQUEST Overview
Tasks performed by
certified service
engineer
Set up
Tasks performed by
the user
* Only for PRIMEQUEST
Notes:
1-2
Equipment setup
MMB connection (test
environment)
MMB connection and setup
(operating environment)
Network setup for normal
operation
MMB initialization
Partition initialization
Mode settings
Saving settings
OS installation
Postinstallation work
Setup of attached software
programs
SNMP security setting
580A/540A/580/540/480/440
GSWB initialization

Figure 1.1 Setup workflow

Before the user can start setup tasks, certified service engineers must have
executed tasks including machine setup, the part of MMB setup they are
responsible for, and test program execution.
Perform inventory checking and BIOS setup and
check partitions using a test program.
Testing is conducted in a created test environment.
Setup the MMB IP address and other parameters to
be used for normal operation and connect to the
MMB. See Section 2.2.1.
Specify parameters for the entire MMB, such as the
user accounts and system name. See
Set the partition names or configure the partition.
See Section 2.5.
Set up the mode when necessary. See
Save the specified setting values (for MMB and
GSWB). See Section 2.6.
GSWB is supported only in PRIMEQUEST 580A/
540A/580/540/480/440.
Install the operating systems. See
Specify the monitoring method, dump environment,
and save the settings (PSA and EFI). See
Set up the attached software programs. See
Appendix A.
Set up SNMP and security.
See Chapter 5.
Set up GSWBs when necessary. GSWBs can
perform basic functions with as-shipped settings.
Basic functions referred to here mean functions that
do not use a GSWB VLAN (as shipped, VLANs are
not configured). Refer to PRIMEQUEST GSWB
User's Manual (C122-E028EN).
Note: The GSWB is an optional product.
Section 2.2.4.
Section 2.5.8.
Chapter 3.
Chapter 4.
C122-E001-10EN