Fujitsu PRIMEQUEST 500A Series Installation Manual page 172

CHAPTER 3 Operating System Installation
• Preparing a SCSI driver disk
1
Format a floppy disk.
2
Insert the Drivers CD into the drive of the separate PC.
3
Using Explorer, access the following folder on the Drivers CD:
E:\Drivers\SCSI\LSILogic (assuming that E is the CD-ROM drive)
4
Select all files in the folder, and copy them to the floppy disk.
• Installation on a built-in SAS disk
Use the SAS driver stored on the "PRIMEQUEST Drivers CD for Microsoft
Windows Server
document).
Prepare a driver disk on a separate PC running Windows.
• Preparing a SAS driver disk
1
Format a floppy disk.
2
Insert the Drivers CD into the drive of the separate PC.
3
Using Explorer, access the following folder on the Drivers CD:
E:\Drivers\SAS\LSILogic (assuming that E is the CD-ROM drive)
4 Select all files in the folder, and copy them to the floppy disk.
4 Click the [Apply] button.
The [EFI Boot Manager] message is displayed on the display connected to the
KVM.
EFI Boot Manager
Please Select a boot option
DVD /Acpi(xxxxxxxx)
Network Boot/Pci(1|0|0)/Mac(0007E9D80F36)
EFI Shell [Built in]
Boot option maintenance menu
Note:
INF file txtsetup is corrupt or missing,status 18.
Setup cannot continue. Press any key to exit.
3-50
®
2003 (C122-E024) (referred to as the Drivers CD, in this
ver 1.xx [xx.xx]
Confirm that the USB floppy disk drive is not installed.
If a floppy disk is inserted into a USB drive, the message shown
below may appear.
If so, press the [Enter] key to allow Windows to reboot, and
disconnect and reconnect the USB floppy disk drive once. Then,
resume this installation process from step 4.
®
C122-E001-10EN