Fujitsu PRIMEQUEST 500A Series Installation Manual page 342

CHAPTER 5 Security Setup
2 Enter the required items.
Up to 64 filters can be set.
Note: When seting a proxy with the Web browser from your computer or
Table 5.2 Displayed and setting items in the [Edit Filter] window
Protocol
Access Control
IP Address
Subnet Mask
3
Click the [Apply] button.
Filter removal
1 Select a filter and click the [Remove Filter] button. A removal confirmation
window is displayed.
2
To remove the filter, click the [OK] button.
The [Access Control] window is then restored, and the user can confirm that the
filter has been removed from the list.
To cancel the removal, click the [Cancel] button.
5-4
workstation, set the IP address taking into consideration the proxy setting.
Item
Sets a protocol subject to IP filtering.
Select one of the following from the pull-down menu.
HTTP, HTTPS, Telnet, SSH, SNMP
Use the [Enable] and [Disable] radio buttons to specify whether
to implement access control.
• If [Disable] is selected, access to the protocol selected above
is enabled for all IP addresses. In this case, entry in the entry
fields of the following [IP Address] and [Subnet Mask] is
disabled.
• If [Enable] is selected, entry in the entry fields of the
following [IP Address] and [Subnet Mask] is enabled to set
an IP address that enables access to the protocol selected
above.
Connection-enabled IP address
Setting example: 192.168.0.0
Subnet mask of connection-enabled IP address
Setting example: 255.255.255.0
Description
C122-E001-10EN