Appendix B Setup Command Workflow - Fujitsu SPARC M12-1 Installation Manual

Appendix B
Setup Command Workflow
This appendix describes the workflow of the XSCF commands executed in
installation of the SPARC M12-1.
For details, see the linked sections listed in
Table B-1 XSCF Setup Command Examples
XSCF Command Example
Making the initial system settings
version -c xcp
showaltitude
setaltitude -s altitude=100
rebootxscf -y -a
showtimezone -c tz
settimezone -c settz -a
settimezone -c settz -s
Asia/Tokyo
showdate
setdate -s 102016592012.00
testsb -v -p -s -a -y
showhardconf -M
showhardconf -u
showlogs error
Description
Displays the XCP version
Displays the system altitude
Sets the altitude
Example: The system altitude is set to
100 m.
Reboots the XSCF
Displays the XSCF time zone
Lists the time zones that can be set
Sets the time zone
Example: "Asia/Tokyo" is set.
Displays the XSCF clock date and time
Sets the XSCF clock date and time
Example: 16:59:00 on 2012/10/20 in
local time (JST) is set.
Performs an initial diagnosis of the
PSB
Displays information on each FRU
Displays the number of mounted
units by FRU
Displays an error log
Table B-1.
Mandatory? Linked Section
Yes "5.4 Checking the XCP
Yes "5.5 Checking the Altitude
Setting"
Optional "5.5 Checking the Altitude
Setting"
Optional "5.5 Checking the Altitude
(*1) Setting"
No "5.6 Setting the
No "5.6 Setting the
Yes "5.6 Setting the
Yes "5.6 Setting the
Yes "5.6 Setting the
Yes "5.7 Performing a Diagnosis
Test"
Yes "5.8 Checking the Component
Status"
No "5.8 Checking the Component
Status"
Yes "5.8 Checking the Component
Status"
Version"
Time"
Time"
Time"
Time"
Time"
121