Fujitsu PRIMEQUEST 500A Series Installation Manual page 403

5 Select the HBA.
From the displayed HBA list, select the one to be used for SAN boot by moving
the cursor to it, and press the [Enter] key. The HBA setup utility menu is
displayed.
----------------------------------------------------------
001: LP10k
----------------------------------------------------------
6
Display of setup menu for HBA setup utility
Select [1. Setup Utility], then press the [Enter] key. The following menu is
displayed.
-----------------------------------------------------------------
001: LP10k
Boot Bios : Disabled
Port Name : 10000000C942E2D6
S_ID
-----------------------------------------------------------------
7
Obtaining the HBA WWPN
Displaying the setup menu for HBA setup utility in step 6 above displays the
HBA WWPN for "Port Name."
8
Initialize the HBA settings.
Select [4. Reset to Default Values] from the menu displayed in step 6.
Enter "y" in the displayed dialog box to initialize the HBA settings.
Do you want to Force defaults (y/n) :
Note:
C122-E001-10EN
Emulex FC EFI-Bios Utility, Ver: 3.10a6
PCI-X
HBA Status: Ready
EFI Boot : TE3.10A6
Emulex FC EFI-Bios Setup Utility, Ver: 3.10a6
PCI-X
Firmware
: 000000 Link Speed: NA
1. Enable or Disable BIOS
2. Configure HBA Parameters
3. Configure Boot Parameters
4. Reset to Default Values
This operation is not required in the system state immediately
following shipment from the factory.
133MHz Bus#: 49 Dev#: 01 Func#: 00
Boot Bios : Disabled
Firmware
1. Setup Utility
2. Firmware Update
133MHz Bus#: 49 Dev#: 01 Func#: 00
: TS1.91A1
Node Name : 20000000C942E2D6
D.4 Settings
: TS1.91A1
I/O Base : 8300
Topology : Invalid
D-9