Table 2.27 Displayed And Setting Items In The [Mode] Window - Fujitsu PRIMEQUEST 500A Series Installation Manual

CHAPTER 2 Setup
2
Set various modes.
Remarks: For details on the Dynamic Partitioning setting, see the PRIMEQUEST

Table 2.27 Displayed and setting items in the [Mode] window

PCI Address Mode
(current status)
(only for PRIMEQUEST
580A/540A/580/540/
480/440)
PCI Address Mode
(setting)
(only for PRIMEQUEST
580A/540A/580/540/
480/440)
Interleave Mode between
SBs (only for
PRIMEQUEST 480/440)
2-68
Figure 2.48 [Mode] window (PRIMEQUEST 420)
580A/540A DP (Dynamic Partitioning) Manual (C122-E085EN).
Item
Displays a PCI address mode that is enabled in the partition.
• [PCI Bus Mode]: Defines all PCI spaces in the partition
under segment number 0.
• [PCI Segment Mode]: Defines the PCI spaces in the
partition, segment by segment, for each IO Unit. When they
are set in [PCI Segment Mode], a PCI device under IOU#0
appears in the space under segment#0, and a PCI device
under IOU#1 also appears in the space under segment#1.
Sets the PCI address mode of a partition.
The set mode is enabled after the partition is reset.
Notes:
• Set PCI Bus Mode for the partition that uses Windows Server
2003 as the OS.
• Set PCI Segment Mode for the partition that uses Linux as
the OS.
• If Linux is installed, PCI Bus Mode must be set.
• For information on how to set the PCI address mode for a
partition running Windows Server 2008, see the
PRIMEQUEST Windows Server 2008 User's Guide
(C122-E087EN).
Note: This mode is displayed for PRIMEQUEST 480/440
Description
machines. However, do not use this mode.
C122-E001-10EN