Fujitsu PRIMEQUEST 500A Series Installation Manual page 404

Appendix D Installation in the SAN Boot Environment
9 Enable the BIOS Boot option.
Select [1. Enable or Disable BIOS] from the menu displayed in step 6.
The following menu is displayed:
EFI-Bios Boot Option is Currently DISABLED.
Select [Enabled].
10 Press the [Esc] key once to return to the window displayed in step 6.
11 Specify the boot device.
Select [3. Configure Boot Parameters] from the menu displayed in step 6.
The following menu is displayed:
1. Device Path Selection
2. Maximum Luns/Target
3. Boot Target Scan
4. Configure Boot Devices
5. Delay Device Dicovery
12 Select [4. Configure Boot Devices]. A list of data is displayed as shown below.
Select an empty entry. All entries are empty in the initial state.
01: DID:000000 WWN:00000000 00000000
02: DID:000000 WWN:00000000 00000000
03: DID:000000 WWN:00000000 00000000
04: DID:000000 WWN:00000000 00000000
05: DID:000000 WWN:00000000 00000000
06: DID:000000 WWN:00000000 00000000
07: DID:000000 WWN:00000000 00000000
08: DID:000000 WWN:00000000 00000000
13 Select [01: DID:0000000 WWN: 00000000 00000000], and press the [Enter] key.
The following menu is displayed:
01: DID:000000 WWN:00000000 00000000 LUN: 0000
D-10
Disabled - default
Enabled
Selected Boot Device in Flash:
1. Scan Targets
2. Clear Flash Boot Info
C122-E001-10EN