Fujitsu PRIMEQUEST 500A Series Installation Manual page 225

4.4.1 Checking the management LAN settings
This section describes how to check the management LAN settings.
For communication of PSA with the MMB via the management LAN, the NIC
connected to the management LAN on the partition side must be active.
(1) Checking the settings for the NIC of the management LAN
Execute the following command to check the interface name assigned to the NIC of
the management LAN.
1
Enter the ifconfig command to list the network interfaces recognized by the
system and confirm the relevant interface name.
Command syntax:
/sbin/ifconfig –a
Example: eth0, eth1, and lo displayed on the left side are interface names.
# /sbin/ifconfig –a
eth0
eth1
lo
C122-E001-10EN
4.4 PSA Installation (Linux: SUSE) (PRIMEQUEST 500A/500/400 series common)
Link encap:Ethernet
inet addr:192.168.1.10
inet6 addr: fe80::2d0:b7ff:fe53:89c3/64 Scope:Link
UP BROADCAST RUNNING MULTICAST
RX packets:1107704 errors:0 dropped:0 overruns:0 frame:0
TX packets:2653820 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:390009908 (371.9 MiB)
Link encap:Ethernet
inet addr:192.168.1.12
inet6 addr: fe80::20e:cff:fe21:8397/64 Scope:Link
UP BROADCAST RUNNING MULTICAST
RX packets:1538726 errors:0 dropped:0 overruns:0 frame:0
TX packets:356 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:341051195 (325.2 MiB)
Base address:0x5cc0 Memory:fbfe0000-fc000000
Link encap:Local Loopback
inet addr:127.0.0.1
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING
RX packets:3865 errors:0 dropped:0 overruns:0 frame:0
HWaddr 00:D0:B7:53:89:C3
Bcast:192.168.1.255
MTU:1500
TX bytes:809006934 (771.5 MiB)
HWaddr 00:0E:0C:21:83:97
Bcast:192.168.1.255
MTU:1500
TX bytes:22862 (22.3 KiB)
Mask:255.0.0.0
MTU:16436 Metric:1
Mask:255.255.255.0
Metric:1
Mask:255.255.255.0
Metric:1
4-39