Fujitsu PRIMEQUEST 500A Series Installation Manual page 171

3.3.5.3 Installing Windows
This section describes how to install Windows on a SAN storage disk or internal disk.
1 Insert the Windows Server 2003 DVD-ROM disk into the OPL DVD-ROM drive.
2
In the MMB Web-UI window, click [Partition]
The [Power Control] window is displayed.
3
Select [Power On] from [Power Control] of the installation target partition.
Remarks: If power to the partition is already on, select [Reset].
• Installation on a SAN storage unit such as an ETERNUS unit
Use the Fibre Channel card driver (FC driver) stored on the "PRIMEQUEST
Drivers CD for Microsoft
the Drivers CD, in this document).
Prepare a driver disk on a separate PC running Windows.
• Preparing an FC driver disk
1
Format a floppy disk.
2
Insert the Drivers CD into the drive of the separate PC.
3 Using Explorer, access the following folder on the Drivers CD:
E:\Drivers\FC\Emulex (assuming that E is the CD-ROM drive)
4
Select all files in the folder, and copy them to the floppy disk.
• Installation on disk connected via SCSI
Use the SCSI driver stored on the "PRIMEQUEST Drivers CD for Microsoft
Windows Server
document).
Prepare a driver disk on a separate PC running Windows.
C122-E001-10EN
Figure 3.28 [Power Control] window
®
Windows Server
®
2003 (C122-E024) (referred to as the Drivers CD, in this
3.3 Windows Installation
→
[Power Control].
®
2003" (C122-E024) (referred to as
®
3-49